Table of Contents
Advertisement
THIS UNIT IS APPROVED FOR INSTALLATION IN FACTORY-BUILT ZERO-CLEARANCE SOLID FUEL
AND MASONRY FIREPLACES.
WARNING:
Failure to use only parts specifically approved with this appliance may result in property damage
or personal injury.
WARNING: CUTTING ANY SHEET METAL PARTS OF THE FIREPLACE, IN WHICH THIS GAS FIREPLACE INSERT
IS TO BE INSTALLED, IS PROHIBITED. ANY SMOKE SHELVES, SHIELDS AND BAFFLES MAY BE REMOVED IF
ATTACHED WITH MECHANICAL FASTENERS.
The existing fireplace must meet the following requirements:
1.
A gas line must be able to be installed to the insert.
2.
Existing Chimney:
- Class "A" metal chimney:
- Masonry Chimney: Co-linear 3" x 4" venting - 6" x 8" minimum inside diameter.
3.
The inside dimensions of the fireplace with the firebrick and smoke baffle REMOVED must be at least:
4.
The height the of existing chimney must be a minimum of 11 ft.
Maximum height of existing chimney: Co-linear venting: 40 ft.
To Determine the length of your existing chimney:
A)
NOTE: It is helpful to have two people complete the next step in determining chimney height:
B)
5.
Minimum clearance from outlet grill on the insert to a combustible mantel:
Minimum clearance from the side of the insert glass (glazing) to side wall:
MINIMUM OPENING DIMENSIONS
Zero Clearance
Solid Fuel Fireplace shown
Co-linear 3" x 4" venting - 8" minimum inside diameter.
Height: 23-1/2"
Depth: 16 1/2" Width at minimum depth location: 23-1/2"
Remove the chimney cap.
With one person at the fireplace and the other person at the top of the chimney, measure
from the base of the fireplace to the top of the chimney. Subtract 24" for the height of the
insert. This is the total length of 4" x 6" flexible aluminum you will require.
MEASUREMENT FROM BASE OF FIREPLACE TO TOP OF CHIMNEY: ____
1
23
"
2
597mm
Front Width: 331/2"
TOTAL CHIMNEY LENGTH REQ.: ____
1
23
"
2
597mm
1
33
"
2
851mm
1
16
"
2
419mm
PAGE 5
LESS:
-24"
12"
10"
Advertisement
Table of Contents
