Table of Contents
Advertisement
F) SECURE THE MASONRY SIDE PANELS, IF INSTALLED.
1. With the panels 'outside' the flange at the bottom of the
insert, align the holes in the masonry side panels to the
holes in the face of the insert and secure with 4 - self-
tapping screws (2 ea. side), see Figure F-1.
Note: If the panels are not placed „outside‟ the flange at
the bottom, it may cause a rattling noise when the
fan is operating.
G) MILLIVOLT BOARD INSTALLATION.
NOTE: The millivolt board must be fitted with a gasket, (included) to seal the board. Make certain this gasket is properly placed around the
opening before installing the millivolt board.
1. Grasp the millivolt board with both hands and place into the unit, lining up the (8) mounting holes to in the board to the (8) mounting studs in the
fireplace bottom.
CAUTION:
BEFORE SECURING THE BOARD INTO PLACE, MAKE CERTAIN THAT ALL OF THE WIRES (ATTACHED UN-
DER THE BOARD) ARE CLEAR AND UNOBSTRUCTED.
2. Attach the (8) 1/4" nuts (using the (2) nuts previously removed and the remaining (6) nuts from the fireplace components packet). Tighten all (8)
nuts.
CAUTION: WHEN INSTALLATION OF THE MILLIVOLT BOARD IS COMPLETE, CHECK TO
ENSURE THAT THERE ARE NOT WIRES, FLEXLINES, ETC. TOUCHING THE FAN TERMINALS.
3
.
Place the burner/cover assembly onto the board, properly seating the burner tube over the orifice and aligning the mounting holes in the burner
cover to the corresponding mounting studs on the bottom of the millivolt board. (Figure G-1).
4.
Install the pilot shield over the pilot assembly. (Figure G-2).
5.
Connect the flexible gas line to the manual shut off valve.
6.
Connect any remote control, wall switch or thermostat wires, if used.
Figure G-1
Figure F-1
Figure G-2
PAGE 14
SELF-TAPPING
SCREW 4X
Pilot Shield
Advertisement
Table of Contents
