Transportation; Transportation Warnings - Quickie Salsa M2 Mini Instructions For Use Manual

Table of Contents

Advertisement

12.0 Transportation

A wheelchair secured in a vehicle will not provide the
equivalent level of safety and security of a vehicle seating
system. Sunrise Medical recommends that the user
transfers to the vehicle seating and uses the vehicle-
installed restraint system wherever possible. Sunrise
Medical recognises that it is not always practical for the
user to be transferred and in these circumstances, where
the user must be transported whilst in the wheelchair , the
following advice must be followed:

12.1 Transportation warnings:

WARNINGS!
The occupied wheelchair must be located in a forward
facing position and secured by the wheelchair tie
down and occupant restraint straps (WTORS),
meeting the requirements of ISO 10542 or equivalent
in accordance with the WTORS manufacturer's
instructions. Refer to the section 'Tie Down
Instructions' for further information on transporting
your wheelchair .
The wheelchair 's use in other positions within a
vehicle has not been tested e.g. transportation in a
side facing position must not be carried out under any
circumstances, (Fig 12.1).
Wherever possible remove and stow safely away from
the wheelchair , all auxiliary equipment, for example,
Kerb climbers, Tray tables, Crutches & Loose
cushions.
Rev.1.0
WARNINGS!
Alterations or substitutions must not be made to
the wheelchairsecurement points or to structural
and frame or components without consulting the
manufacturer. Failure to do so will invalidate the ability
of the wheelchair to be transported within a vehicle.
The wheelchair should be inspected by a Sunrise
Medical authorised dealer before re-use following
involvement in any type of vehicle impact.
WARNING!
Both pelvic and upper torso restraint belts must be used
to restrain the occupant to reduce the possibility of head
and chest impacts with the vehicle components, (Fig
12.2).
WARNINGS!
This wheelchair has been successfully crash tested.
Sunrise Medical recommends that you use a suitably
positioned headrest when being transported in the
wheelchair . However it is highly recommended that
as a preference you transfer from your wheelchair to a
seat within the motor vehicle.
Postural supports (lap straps, lap belts) should not be
used or relied on for occupant restraint in a moving
vehicle unless they are labelled as meeting the
requirements specified in ISO 7176-19.
Spill proof sealed batteries such as "gelled electrolyte"
or "AGM" must be installed on powered wheelchairs
when used in a motor vehicle.
Fig.12.2
Fig.12.1
57
SALSA M
2
Mini

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Salsa M2 Mini and is the answer not in the manual?

Questions and answers

Cheryl Grey
March 17, 2025

n you please advise

Cheryl Grey
March 17, 2025

Connecting VR2 with 2 actuators to Salsa Mini M2. Please advise how to replace.

1 comments:
Mr. Anderson
May 14, 2025

To connect the VR2 control with 2 actuators to the Quickie Salsa M2 Mini:

1. Ensure the VR2 control system is programmed for actuator operation.
2. Use the actuator button on the VR2 control panel to operate the actuators.
3. Each actuator function (e.g., seat lift or tilt) must be assigned to the actuator button.
4. You can reverse actuator direction relative to joystick movement if needed.
5. If no actuators are programmed, the actuator button has no function.

Make sure the control system is correctly set for the desired actuator functions.

This answer is automatically generated

Table of Contents

Save PDF