Table of Contents
Advertisement
5.8 Armrests
5.8.1
Armrests Flip Up, Standard Armrest.
The armrests on both sides of the wheelchair can be flipped
up to allow side transfer, (Fig. 5.18).
•
For side transfer flip the armrest all the way up until it
goes into its mechanical stop. This frees your space for
side transfer.
•
To bring the armrests back into their position flip it all the
way down until it sits on its mechanical stop. Guide it in
its downward movement and do not let it fall on its own.
Armrest Flip Up, Reclining arm rest:
NOTE: The recline armrest flip up, is exactly the same
as the standard armrest.
The armrests on both sides of the wheelchair can be flipped
up to allow side transfer, (Fig. 5.18).
•
For side transfer flip the armrest all the way up until it
goes into its mechanical stop. This frees your space for
side transfer.
•
To bring the armrests back into their position flip it all the
way down until it sits on its mechanical stop. Guide it in
its downward movement and do not let it fall on its own.
5.8.2
Standard and Recline Armrest Fine Height
Adjustment, up to 25 mm:
1. Use a 5.0 mm Allen key, (hexagon wrench), to loosen
the two arm pad angle pivot bolts (A) on both armrests.
(Fig.5.19).
2. Use a 6.0 mm Allen key, (hexagon wrench), to loosen
the rotation bolts on both armrests (B).
3. Use a 5.0 mm Allen key, (hexagon wrench), to rotate the
height adjustment screw (C) to fine tune the height. Turn
counter-clockwise to increase height or clockwise to
lower, (Fig.5.20).
4. Tilt both arm pads down, (or up in the case of a lowered
armrest), until the arm pads are in the preferred angle.
Check to see if the height is correct, Retighten both
armrest pivot bolts, (A). (Fig.5.21).
5. Rotate (C) for fine adjustment.
6. Retighten the 6mm rotation bolts on both armrests, (B).
(Fig.5.19).
7.
Use 20 N/m or 177 in/lb of torque.
8. Retighten both arm pad angle pivot bolts "A". Use
10 N/m or 88.5 in/lb of torque for both sets of bolts,
(Fig.5.22).
WARNING!
Check all bolts periodically for tightness. If loose the armpad
could slip down when pressed.
22
SALSA M
2
Mini
A
Fig. 5.19
C
Fig. 5.20
A
Fig. 5.21
Fig. 5.22
Fig. 5.18
B
A
Rev.1.0
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Salsa M2 Mini and is the answer not in the manual?
Questions and answers
n you please advise
Connecting VR2 with 2 actuators to Salsa Mini M2. Please advise how to replace.
To connect the VR2 control with 2 actuators to the Quickie Salsa M2 Mini:
1. Ensure the VR2 control system is programmed for actuator operation.
2. Use the actuator button on the VR2 control panel to operate the actuators.
3. Each actuator function (e.g., seat lift or tilt) must be assigned to the actuator button.
4. You can reverse actuator direction relative to joystick movement if needed.
5. If no actuators are programmed, the actuator button has no function.
Make sure the control system is correctly set for the desired actuator functions.
This answer is automatically generated