Operation - Silvercrest SDM 1500 B2 Operating Instructions Manual

NOTE
If the mains water in your location is rated as hard, it is recommended that
you mix the mains water with some distilled water. Otherwise, the jets for
the steam blast function could calcify (become blocked) prematurely.
To extend the optimal steam blast function, mix mains water with
distilled water according to the table:
Water hardness
The water hardness level can be queried at your local water works.
4) Attach and hand-tighten the clamp.
5) Turn the water tank
First fit the lower part into the main unit
device. Push it firmly into place so that the water tank
place and sits firmly on the main unit

Operation

CAUTION – PROPERTY DAMAGE!
► If you are not sure whether the floor is suitable for cleaning, please carry
out a tolerance test using a concealed part of the floor.
► Never use the appliance without a pad
Otherwise the floor could get scratched!
► Never operate the appliance without water in the water tank
The pump could overheat and be damaged!
NOTE
► Before you clean the floor with the steam mop, we recommend that you
vacuum the floor to remove any loose particles of dirt.
Once the appliance is assembled and filled with water:
1) If not already done: Completely unwind the power cable from the cable
hooks
upper cable hook
SDM 1500 B2
very soft/soft
medium
hard
very hard
around again and place it back onto the main unit
/ . To facilitate the unwinding of the cable, you can flip down the
by pulling it out a little and simultaneously turning it.
Ratio of distilled
water to
tap water
0
1:1
2:1
3:1
and then flip the top part into the
.
on the steam foot
audibly clicks into
.
!
GB │ IE │ CY │
9 ■
: