Operation; Filling The Water Tank - Silvercrest SDMF 1300 A1 Operating Instructions And Safety Instructions

Operation

Filling the water tank

WARNING – RISK OF INJURY!
► Never fill the water tank
► Never submerge the steam head
NOTE
► The appliance should only be used with tap water or distilled water for
steaming. If your tap water is hard, we recommend that you mix it with
distilled water. Otherwise, the appliance will accumulate limescale quickly.
Mix the tap water with distilled water in accordance with the following
table for optimal performance.
Information about the level of hardness of water in your area can be
obtained from your local water company.
► Never use water that contains additives (e.g. starch, perfumes, softening
agents) or condensation (e.g. from dryers, refrigerators, air conditioning
units or rain). These may contain organic or mineral residues that accumu-
late when exposed to heat and can cause noise, brown discolouration and
premature failure of the appliance.
1) Remove the mains plug from the power socket if connected.
2) Remove the water tank
buttons
straight out of the appliance (fig. A).
3) Open the lid
indicates the maximum fill level.
4) Close the lid
The water tank
■ 62 │ GB │ MT
0
Water hardness
very soft/soft
medium
hard
very hard
0
from the appliance by pressing the release
7
on the left and right side and then pulling the water tank
9
and fill the water tank
9
and replace the water tank
0
must audibly click into place.
through the holes in the steam head
5
under water.
Ratio of distilled
water to mains water
0
1: 1
2: 1
3: 1
0
(fig. B). The MAX mark
0
in the appliance.
5
.
0
SDMF 1300 A1