Operation; Filling The Water Tank - Silvercrest SDMF 1300 A1 Operating Instructions And Safety Instructions

Operation

Filling the water tank

WARNING – RISK OF INJURY!
► Never fill the water tank
► Never submerge the steam head
NOTE
► The appliance should only be used with tap water or distilled water for
steaming . If your tap water is hard, we recommend that you mix it with
distilled water . Otherwise, the appliance will accumulate limescale quickly .
Mix the tap water with distilled water in accordance with the following
table for optimal performance .
Information about the level of hardness of water in your area can be
obtained from your local water company .
► Never use water that contains additives (e .g . starch, perfumes, softening
agents) or condensation (e .g . from dryers, refrigerators, air conditioning
units or rain) . These may contain organic or mineral residues that accumu-
late when exposed to heat and can cause noise, brown discolouration and
premature failure of the appliance .
1) Remove the mains plug from the power socket if connected .
2) Remove the water tank
buttons
straight out of the appliance (fig . A) .
3) Open the lid
indicates the maximum fill level .
4) Close the lid
The water tank
■ 8 │ GB │ IE │ NI │ CY
0
Water hardness
very soft/soft
medium
hard
very hard
from the appliance by pressing the release
0
on the left and right side and then pulling the water tank
7
and fill the water tank
9
and replace the water tank
9
must audibly click into place .
0
through the holes in the steam head
under water .
5
Ratio of distilled
water to mains water
0
1: 1
2: 1
3: 1
(fig . B) . The MAX mark
0
in the appliance .
0
.
5
0
SDMF 1300 A1