Handling And Operation; Filling With Water - Silvercrest 331382 1907 Operating Instructions Manual

Handling and operation

This section provides you with important information on handling and using the
appliance.

Filling with water

CAUTION! PROPERTY DAMAGE!
Never operate the appliance without water in the water tank 8!
►
The pump could overheat and be damaged!
Do not fill the water tank 8 with any cleaning agents or other additives.
►
1) Push the "Water tank" release button 9 upwards and simultaneously
remove the water tank 8.
2) Turn the water tank 8 and unscrew the cap.
3) Fill the water tank 8 with tap water up to the MAX mark.
NOTE
If the mains water in your location is rated as hard, it is recommended
that you mix the mains water with some distilled water. Otherwise, the
jets for the steam blast function could calcify (become blocked)
prematurely.
To extend the optimal steam blast function, mix mains water with distilled
water according to the table:
Water hardness
The water hardness level can be queried at your local water works.
4) Attach and hand-tighten the clamp.
5) Turn the water tank 8 around again and place it back onto the main unit 3:
First fit the lower part into the main unit 3 and then flip the top part into the
device. Push it firmly into place so that the water tank 8 audibly clicks into
place and sits firmly on the main unit 3.
SDM 1500 D2
water to tap water
very soft/soft
medium
hard
very hard
Ratio of distilled
0
1:1
2:1
3:1
GB │ MT │
27 ■