Setting Parameters On The Sip Ag Interface - Huawei AR1200 Series Configuration Manual - Voice

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
voice
The voice view is displayed.
Step 3 Run:
voip-address media interface interface-type interface-number { ip-address |
dynamic }
A media IP address pool is configured.
Step 4 Run:
voip-address signalling interface interface-type interface-number { ip-address |
dynamic }
A signaling IP address pool is configured.
When configuring media and signaling IP address pools:
l To specify the ip-address parameter, ensure that an IP address has been configured for the
l To specify the dynamic parameter, ensure that an IP address has been dynamically assigned
----End

1.4.3 Setting Parameters on the SIP AG Interface

This section describes how to set parameters on a SIP AG interface.
Context
On the IMS, when the MGC and the SIP AG exchange media and signaling streams, set the
media and signaling IP addresses, signaling port number, and transmission protocol.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
voice
The voice view is displayed.
Step 3 (Optional) Run:
local-digitmap name name-value { type { normal | emergency | scc | direct-centrex
| second-centrex } | body body-value [ append ] }*
The digitmap is configured.
Issue 03 (2011-09-30)
specified interface.
to the specified interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SIPAG Configuration
8