Huawei AR1200 Series Configuration Manual - Voice page 54

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice
The SIP AG ID is configured for the SIP AG user.
Step 6 Run:
base-telno telno-value
The phone number is configured for the SIP AG user.
Step 7 Set optional parameters for the SIP AG user.
Parameter
Sub-channel
active mask
Maximum
number of
automatic
recovery
attempts from
deterioration
SIP AG's
capability to
support the
BELL ANS
flag
Calling
number format
Sequence in
which the
calling number
of a SIP AG
user is
displayed
Power-off
interval
Single-tone
ANSbar signal
detection
DSP chip input
gain
DSP chip
output gain
DSP template
name
Issue 03 (2011-09-30)
Command
active-mask mask
NOTE
This command is valid only on VE1 interfaces.
auto-resume-limit auto-resume-limit
NOTE
This command is valid only on VE1 and BRA
interfaces.
bell-ans-flag { enable | disable }
clip-format { sdmffsk | mdmffsk | dtmf |
r15 | etsi }
clip-transmission-sequence { after-ring |
before-ring }
dc-time dc-time
detect-ansbar-by-single-tone { enable |
disable }
dsp-input-gain dsp-input-gain
dsp-output-gain dsp-output-gain
dsp-template dsp-template
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SIPAG Configuration
Default Setting
255.255.255.255
20
disable
FSK simple data format
after-ring
10 ms
disable
0 dB
0 dB
No DSP template name
configured
48