To open this menu you will be asked to enter your access code.
From the factory the access code is set to 1234.
The following settings can be altered from this menu.
If you select On, you will have to enter the access code every
time you start the Mediamaster from standby.
Age Rating Control
If you want everybody to have access to all available types of pro-
grammes, select Off.
If you select On, you may block programmes unsuitable for chil-
dren. Select an age limit between 4 and 18 years on the line that
However, you should be aware that not all Service Providers have
the necessary codes for these functions implemented in their
Change access code
From here you can change the access code from the stand-
ard 1234. DO NOT FORGET IT! Without it you do not have ac-
cess to any of the functions where the code is required!
When you switch channels, an information banner will be shown
for a few seconds. You can select for how long the banner will
Select whether or not you want the volume bar to appear on the
screen when you change the volume.
Volume bar time-out
Select how long the banner will be visible on the screen.
Select whether or not subtitles will be visible on the screen. In
case you want to control the Teletext function with your TV re-
mote control, this parameter must be set to Invisible.
If you have a TV set with the 4:3 picture format and the transmis-
sion is in 16:9, you can select Fullscreen or Letterbox.
Fullscreen will fill up the screen but cut off some information on
the left and right sides.
Letterbox will give a complete picture, but leave black areas at
the top and bottom.