Table 19 Advanced - Call Features - Grandstream Networks GAC2500 Administration Manual

Guest Login
Guest Login Timeout (m)
Guest Login PIN Code
SIP Domain

Table 19 Advanced - Call Features

Disable Call-Waiting
Display Soft Keyboard
Filter Characters
Disable Call-Waiting Tone
Disable DND Reminder Ring
Disable Direct IP Call
Use Quick IP-Call Mode
Disable Transfer
Default Transfer Mode
Escape '#' as %23 in SIP URL
Firmware Version 1.0.1.34
Enable or disable guest login. If enabled, users need to configure the
SIP domain name. After reboot, it is required to fill in SIP user name and
password on LCD.
Configures guest login timeout. If user logs in as guest, it will
automatically log out when no operation for a while.
When Guest Login mode is enabled and
set to "Never", users need to input
setting is empty.
Configures SIP domain name. Fill in SIP server address to register in
AVAYA mode. It should take effect with Outbound Proxy option under
Account->Network Settings.
Disables the call waiting tone when call waiting is on. If it is checked,
the phone system will reject the second incoming call during an active
session without user's knowledge. But this missed call record will be
saved to remind users. The default setting is "No".
Specifies whether to display soft keyboard on dial screen. Please note
that if check, it is recommended to disable dial plan on Account page
the same time, or the call may fail if dial characters that do not match
dial plan. The default setting is "No".
Configures the characters to filter when dial in/out, you can set multiple
characters. E.g. set "[()-]", when dial (0571)-8800-8888, the characters
"()-" will be filtered automatically and dial out 057188008888.
It is used to set if the phone system will play the call waiting tone if there
is another incoming call. If it is set to "Yes", the phone will only display
the indicator on the LCD screen for another incoming call. The default
setting is "No"
Disables the DND reminder ring. If set to "Yes", the ring splash that
indicates an incoming call when DND is enabled will not be played. The
default setting is "No".
It is used to set if the phone system allows the end users to make an
outbound IP call. If it is set to "Yes", the phone will hide the IP call
feature and end users will not be allowed to make an outbound IP call.
The default setting is "No".
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, offhook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
It is used to set if the phone system allows user to transfer an active call
to another party. If it is set to "Yes", the phone system will block the
TRANSFER key on the LCD screen. The default setting is "No".
It is used to set the default transfer mode for the phone system. If the
Blind Transfer or Attended Transfer mode is set, the phone system will
use the specific mode to transfer an active call. The users still have
privilege to switch the mode on the LCD screen when they tap the
transfer key. The default setting is "Blind Transfer"
It is used to set what characters will be included in the SIP INVITE URI
if end users input #. If it is set to "Yes", the phone system will replace
the # by %23. Otherwise, it will include # in the SIP INVITE message.
GAC2500 Administration Guide
"Guest Login Timeout
PIN code to log in. The default
Page 30 of 54
(m)" is