Table 3 Account Settings Parameters; Table 4 Ucm Auto Config Number Settings Parameters - Grandstream Networks GAC2500 Administration Manual


Account. Tap on one account and fill in the necessary information to register the account, which
includes Account Active, Account Name, SIP Server, SIP User ID, SIP Auth ID, SIP Auth Password,
Voice Mail User ID and Display Name.

Wireless & network. Users can configure Ethernet, Wi-Fi, VPN, PPPoE and other advanced settings.
Users can configure Ethernet, Wi-Fi, VPN, PPPoE and other advanced settings under Network.

Security settings. Configure the idle screen lock, credential management, encryption phone and
device administrator, etc.

Upgrade. Fill in upgrade info.

Syslog. Select the level of logging for syslog, and he URL/IP address for the syslog server.

Factory Reset. Open and tap on Factory Reset to restore the GAC2500 to factory default settings.

Clear Master-slave Remember. Clear master-slave choose history.

Developer mode. This mode can be used via ADB tool for advanced debugging purpose.

Table 3 Account Settings Parameters

Parameters Descriptions
Account Select account.
Account This field indicates whether the account is active. If disabled, the GAC2500 will not
Activation send registration information to SIP server.
Account Name The name associated with account to be displayed on the upper left corner of LCD.
SIP Server The URL or IP address, and port of the SIP server. This is provided by your VoIP
service provider (ITSP).
SIP User ID This is the SIP User ID provided by your VoIP service provider (ITSP). It's usually in
the form of digits similar to phone number or actually a phone number.
SIP SIP service subscriber's Authenticate ID used for authentication. It can be identical
Authentication ID to or different from the SIP User ID.
SIP The account password required for the GAC2500 to authenticate with the ITSP (SIP)
Authentication server before the account can be registered.
Password
Voice mail access This parameter allows you to access voice messages by entering voice mailbox or
number dialing access number.
Display Name This is the SIP server subscriber's name (optional) that will be used for Caller ID
display. This function is available when supported by SIP server.
Show account Check this option to display account name only on LCD account widget.
name only
Tel URI If the account is assigned a PSTN number, this field should be set to ""User=Phone".
Then a "User=Phone" parameter will be attached to the Request-Line and TO"
header in the SIP request to indicate E.164 number. If set to "Enabled", "Tel" will be
used instead of "SIP". Default is "Disabled".

Table 4 UCM Auto Config Number Settings Parameters

Parameters Descriptions
Firmware Version 1.0.1.34 GAC2500 Administration Guide Page 14 of 54