Table 20 Advanced - Tone Generator; Table 21 Advanced - Tone Generator Settings - Grandstream Networks GAC2500 Administration Manual

Voice Mode
Conference Server
Enable Conference Room
Quite Mode
Record Mode

Table 20 Advanced - Tone Generator

Auto Config CPT by Region
Dial Tone
Ring Back Tone
Busy Tone
Reorder Tone
Confirmation Tone
Call-Waiting Tone
PSTN Disconnect Tone
Default Ring Cadence

Table 21 Advanced - Tone Generator Settings

Auto Config CPT by Region
Firmware Version 1.0.1.34
The default setting is "Yes".
Configures sound EQ of a call. "Large room" is a room about 33 * 33
feet, and "Small or medium room" is a room about 23 * 23 feet.
voice" would make voice with lower frequency and sounds rich. "Clear
voice" would make voice with higher frequency and sounds clear.
Default setting is "Large room & Clear voice".
Configure the call is always in a conference or not. When checked, all
calls will occur in a conference display. Default setting is unchecked.
Enable Conference Room Quiet Mode: Configures whether to enable
voice prompt when conference members enter or exit the conference.
Once enabled, when a member enters or exits the conference,
members online can hear the corresponding voice prompt. The default
is "No".
Configures phone recording mode. If set to "Record locally", then will
use the local tape recorder for recording, and the audio file will be
saved in accordance with the tape recorder setup. If set to "Record on
server", then will send the recording feature code to the UCM server to
request for recording, and the recording function will be executed by the
server. The default setting is "Record locally".
If set to "Yes", it will configure CPT by region automatically; If set to
"No", you can configure CPT manually. The default setting is "No".lt
Users can configure ring or tone frequencies based on parameters from
the local telecom provider. By default, they are set to the North
American standard. Please refer to the User Manual for details.
Users can configure ring or tone frequencies based on parameters from
the local telecom provider. By default, they are set to the North
American standard. Please refer to the User Manual for details.
Users can configure ring or tone frequencies based on parameters from
the local telecom provider. By default, they are set to the North
American standard. Please refer to the User Manual for details.
Users can configure ring or tone frequencies based on parameters from
the local telecom provider. By default, they are set to the North
American standard. Please refer to the User Manual for details.
Users can configure ring or tone frequencies based on parameters from
the local telecom provider. By default, they are set to the North
American standard. Please refer to the User Manual for details.
This configures the call-waiting tone gain. By default, they are set to the
North American standard. Users could adjust the tone frequencies
based on parameters from the local telecom provider. Users could
select "Low", "Medium" or "High". The default setting is "Low".
Users can configure ring or tone frequencies based on parameters from
the local telecom provider. By default, they are set to the North
American standard. Please refer to the User Manual for details.
This defines the ring cadence for the phone. The default setting is: c=2000/4000.
If set to "Yes", the phone will configure CPT (Call Progress Ton
e) according to different regions automatically. If set to "No", yo
u can configure CPT parameters
manually. The default settings is "No".
GAC2500 Administration Guide
"Rich
Page 31 of 54