Assign Outside ( Co ) Line Access Mode - PABX 208AC Instruction Manual

Chapter Three

3.50 Assign Outside ( CO ) Line Access Mode

Format 1: * 82 ABCD N #
ABCD = Extension number
N is outside ( CO ) line access mode:
N = 0 = Access CO line by dial 0 ( here N can be 9 also )
N = 1 = Access CO line directly
Format 2 : * 8 00 # ( Assign all extensions access CO line by dial 0 )
Format 3 : * 8 10 # ( Assign all extensions access CO line directly )
Description: When N = 0, extension will be at intercom state as soon as lifts handset,
he can input extension number directly to make internal call; but when
make outside call, he must to dial 0 to get external dial tone before input
outside call number.
When N = 1, extension will enter an idle CO line as soon as lifts handset,
user can make outside call directly; but when make internal call, he needs
to dial * to get internal dial tone before input extension number.
Example: Assign extension 8008 is at direct access CO line mode.
Operating: 1) Lifts extension 8001, unlock system;
2) Input * 82 8008 1 # ;
1. At factory default mode, all extensions are access CO line by dial 0, user can
change it to access CO line by 9 if necessary, refer 3.50.1 for related setting.
When use 9 for CO line, user must to input N = 9 in above setting.
2. We are suggest to assign direct access CO line mode for the extension that
is contact outside frequently;
3. When N = 1, if all CO lines are busy, this extension will enter intercom
state as soon as lifts handset, here allows user dial extension number
directly ( no need * ahead extension number);
4. At any access mode, extension must to input at least 3 digits within 10
seconds, otherwise, the line will be released.
3.50.1 Access CO Line Code & One-Touch Calling Operator Assignment
Format: * 0408 MN #
M = Access CO Line Code
( Default is M = 0)
N = Code for operator
When M = N means disable one-touch calling for operator.
Description: System default setting is access CO Line by press 0 and press 9 for operator,
however, to meet different using habit, allows user change it to access CO
line by 9 and 0 for operator, as well as allows disable one-touch calling
operator in some case.
Example 1: Original setting is press 0 to access CO line and 9 for opeator, here user wants
to change setting to press 9 for CO line and 0 for opeator.
Operating 1: 1) Unlock extension 8001 by format * 01 1234 # (1234 is system password)
2) Input * 04 08 9 0 #
System Program
32