Table of Contents
Advertisement
Chapter Three
3.1 Before System Programming
This system has factory default settings ( refer 3.4). If any of programming needs to be
changed, you can change the setting by system programming.
Default setting shows you the factory default setting.
1. System programming can only be performed from extension 8001;
2. Required Telephone Set: DTMF dial mode;
3. Start with * key, and end with # key, allows use * key to re-program if any error
occur during programming, need not hangup;
"
4.
Your instructions are successful
"
You have entered an incorrect instruction, try again later
is invalid.
3.2 Unlock System Password
Format : * * 01 ABCD #
ABCD = System password
Description: Password is required for entering the system programming mode.
Example: Unlock system by password before system program.
Operating: 1) Lifts extension 8001;
2) Input ** 01 1234 #, hear
Keep off-hook and start programming;
1. Password is 1234 at factory default mode;
2. Please keep extension 8001 is off-hook, you can continue programming
by entering program format.
3. If extension 8001 is hangup during programming, you need to input
password to unlock system before new programming;
4. Herein after, all programming is after unlock system by password.
3.3 Change System Password
Format : * 02 ABCD #
ABCD = System new password.
Example: Change password to 5678.
Operating: 1) Lifts extension 8001, unlock system by default password 1234;
2) Input * 02 5678 #;
1. Password is 1234 at factory default mode, suggest administrator change
system password first before using;
2. In the case of forget password, please contact with service center.
System Program
"
informs you that setting is successfully, on contrary,
"
System unlocked is successful, you can start operating
15
"
informs you that the entry
"
.
Hide quick links:
Advertisement
Table of Contents
