For Simple Stack Users - Christie LWU900-DS User Manual

Installation

For Simple Stack users

1.
Press the MENU button on the remote control to display the menu on Set A.
2.
Use the ▲/▼/◄/► buttons to open the TEMPLATE
dialog, then select STACK on the dialog.
(Operating Guide
3.
Press the MENU button on the control panel of
Set B to display the menu.
4.
Use the ▲/▼/◄/► buttons to select 3D KEYSTONE
from EASY MENU, or the SETUP menu of
ADVANCED MENU.
MENU or SETUP
3D KEYSTONE dialog appears on screen.
Set TEST PATTERNS settings to ON to display the
test pattern.
5.
Using 3D KEYSTONE on Set B, adjust the image size
and position of Set B to superimpose well to the image
of Set A. Adjust 3D KEYSTONE in the following ways.
(1) Roughly adjust the four corners in the order below.
Top left → Top right → Bottom right → Bottom left
(2) Fine adjust the four corners in the same way.
NOTES for all users
of EASY MENU
• It is strongly recommended to use a flat screen. If a curved or skewed screen
is used, it is difficult to align the two images even if you use the pin/barrel
adjustment of 3D KEYSTONE.
• Even through fine adjustment of the images from the two projectors, it may not
be possible to superimpose the images depending on the input signals. In this
case, try the following methods.
- Press the AUTO button on the remote control or execute AUTO IMAGE
(Operating Guide
- Adjust H POSITION and V POSITION
POSITION menu) on each of the projectors.
- Check the RESOLUTION setting in the INPUT menu, and change to the same
setting if the setting differs between Main and Sub.
INPUT menu)
LWU900-DS/LHD878-DS/LWU755-DS
User's Manual - Instant Stack Guide
→
MENU
(Operating Guide
menu)
• For details on 3D KEYSTONE, refer to
or SETUP menu
→
SIZE AND POSITION
PREFERENCES)
→
EASY
in the Operating Guide.
menu) on each of the projectors.
(Operating Guide
12
STACK of TEMPLATE
3D KEYSTONE dialog
on STACK of TEMPLATE
3D KEYSTONE
→
SIZE AND
(Operating Guide
020-001617-01 Rev. 1 (12-2018)
LIT MAN USR DS Series ISG
→