Table of Contents
Advertisement
2.3
Test Mode
In test mode, there are various functions available for service technicians to test equipment during
maintenance.
2.3.1
Function test
The function test checks each function of the equipment. To enter the function test mode, follow the
procedure below, or enter the Service mode (*,#,*,*) and select the menu for the function test.
<Key used in operation>
1
3
Power ON
or
ENTER
The following tests can be conducted in the function test mode.
This section only describes PRINT TEST and MODEM TEST as the functions available by attaching
the fax kit.
For the other tests, refer to the Service Handbook for e-STUDIO165/167/205/207/237.
01. OPE PANEL TEST
02. PRINT TEST
03. MODEM TEST (Factory test)
04. SENSOR TEST
05. SRAM TEST
06. DRAM TEST
07. CLOCK IC TEST
08. SCANNER TEST
09. CODEC TEST
10. OUTPUT TEST
11. PRINTER BOARD TEST
*1: When the FAX kit (GD-1220/1221) is not installed, the test is not present.
*2: When the Network Printer kit (GA-1190) is not installed, the test is not present.
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Select test menu
*1
*2
2 - 5
08/08
<Display messages>
GD-1220/1221
SELF-DIAGNOSIS MODE
2
Advertisement
Table of Contents
