Toshiba GD-1220 Service Handbook page 11

Code
Maintenance User
B5 80
C0 85
C1 83
C2 85
C3 83
C4 83
D0 80
D1 82
D2 86
E0 21
E6 21
F0 83
F1 83
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Cause
CFR (FTT) was not detected.
Image signal carrier was not detected.
High-speed signal was not detected on
the receiving side.
After detecting the image signal, carrier
off was detected on the receiving side.
After detecting a high-speed signal, EOL
was not detected on the receiving side.
The EOL timer has timed out.
Post response signal was not detected
on the sending side.
Post signal was not detected on the
receiving side.
DCN is received.
RTN/PIN/ERR is received on the send-
ing side.
RTN/PIN/ERR is received on the receiv-
ing side.
A printer error occurred during a recep-
tion, and the machine is shifted into
memory reception mode. How ever,
there was not enough residual memory.
An error relating to the printer has
occurred.
The communication ended because of a
watchdog timer due to an overrun of the
software.
The communication ended because of
an overrun of the software due to hard-
ware noises.
1 - 3
Remedy
This may happen in some cases of bad
line condition. Attempt the transmission
again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
This may happen in some cases of bad
line condition. Attempt the transmission
again. Or ask the remote party to attempt
the transmission again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
Remove the cause of the printer error,
then ask the remote party to transmit
again.
Confirm details of the error using the
error code and correct the error. Then
ask the remote party to transmit again.
Attempt the communication again. If the
error occurs frequently, perform a mem-
ory clear (except user area.)
Attempt the communication again. If the
error occurs frequently, perform a mem-
ory clear (except user area.)
1
GD-1220/1221
ERROR CODES