Toshiba GD-1220 Service Handbook page 10

Hide thumbs Also See for GD-1220:

Service manual (82 pages)

Operator's manual (262 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

123

124

125

126

Table of Contents

1) Error code list

If an error occurs during communication, an error code is printed in the "STATUS" column of the

transmission/reception journal. Clear the error, referring to the following list.

Error codes for service technicians are printed in the transmission/reception journal output in the

TEST MODE.

Code

Maintenance

User

GD-1220/1221

ERROR CODES

Cause

There was no recording paper or the

paper cassette was not installed during

the reception.

A recording paper jam occurred during

the reception.

A document jam occurred.

During the transmission, any cover was

opened and the transmission stopped.

A power failure occurred during the

transmission or reception, and the trans-

mission/reception original data was lost.

The [CLEAR/STOP] key was pressed

during the communication, and the com-

munication was stopped.

The set number of original pages did not

match the actual pages transmitted.

The polling password did not match, or

no polling document existed.

During a memory transmission or a

memory reception, the machine ran out

of image memory. The machine's image

memory was exhausted.

Dialing and redialing was attempted as

many as the specified count but the line

was busy.

The password did not match in a Relay

or Mailbox transmission, and the trans-

mission ended in failure.

DIS (GI) could not detected.

DIS/NSF that cannot be handled by the

sender is received.

The receiver received NSS/DCS other

than those declared by DIS/NSF.

DCN is received.

DCS/DTC was not detected.

The sender performed fall-back but the

transmission was not enabled. The

receiver was not detect TCF or detected

DCN after sending FTT.

Supply recording paper and insert the

paper cassette firmly.

Remove the jammed recording paper.

Remove the jammed original, then try

the transmission again.

Attempt the transmission again.

Attempt the transmission or reception

again.

Attempt the transmission or reception

again.

Check the actual original count.

Check the polling password or check if

there is a polling original on the remote

party's side, and attempt the polling

reception again.

Divide the originals into several trans-

missions for a memory transmission.

For a memory reception, remove the

cause of the error, then ask the remote

party to transmit the original again.

Confirm the phone numbers of the

remote party.

Confirm that both parties are using the

same system password and the both

units are compatible. Then, ask the

remote party to transmit again.

This may happen in some cases of bad