Table of Contents
Advertisement
3.1
CONNECTING THE BATTERY PACK
a)
To prevent un-necessary battery drain, the battery pack that is
used to power the remote control function for this product is
disconnected at the factory. Prior to attempting to light the product, can
the installer please ensure that the battery pack is re-connected as
described in section b), c) & d) below.
b)
Remove the bezel cover by removing the 2 off black hexagonal
screws on the bottom edge, lift the bezel clear. Unscrew the black
painted shield, which is held in place by 2 off screws, 1 at the L/H/S and
1 at the R/H/S. Locate the battery pack in the support cradle at the
bottom R/H side of the fire. The tray that contains the battery pack can
be slid forwards by removing the single retaining screw at the base of
the tray.
c)
The wire and connecting plug from the battery pack should then be
connected into the supply wire running from the control board. See Fig
6 below.
Fig. 6
d)
Replace the battery pack into its mounting cradle below the fire / burner
and re-assemble in reverse order.
Battery
Pack
Connecting Wire
Connecting
Plug
13
Hide quick links:
Advertisement
Table of Contents
