Flavel REGENT L.F.E. RC Installation, Maintenance & User Instructions page 28

WARNING
If the fire goes out for any reason or is turned off and it is
necessary to relight the fire it is important to allow the fire to cool
for 3 minutes before attempting to re-light it.
TURNING THE PRODUCT OFF IN THE UNLIKELY EVENT OF A REMOTE
HANDSET MALFUNCTION.
a) In the unlikely event of the remote control handset malfunctioning (or if
lost or broken) after the appliance has been turned on, the fire can be
turned off via the emergency shut off switch on the right hand control panel.
b) Press and hold the emergency shut off switch until the fire shuts down.
The process may take up to sixty seconds to complete. (see Fig. 2
below).
c) When the fire has shut down, release the emergency shut off switch.
d) The appliance will now remain in the "off" position until activated by the
remote handset.
Fig. 2
REPLACING THE BATTERIES (REMOTE CONTROL MODELS ONLY)
ENSURE THE FIRE IS COOL BEFORE REPLACING BATTERIES
Remove the front bezel by unscrewing the retaining screws from the bottom face.
Remove the heat shield by removing the 2 off screws at the L/H/S & R/H/S. The
battery pack is located on the right hand side side of the burner unit at the bottom.
Carefully remove the pack and remove batteries. Replace in the reverse order
using 6 off 1.5V AA Alkaline Battery. It is important that only an alkaline battery
is used, otherwise premature battery failure and leakage may result.
5
Emergency Shut Off
Switch Position on
Control Panel.