Other Settings; Ir Source Routing; Front Panel Ir Enable; System Ir Enable - Binary B-120-HDMATRIX-4x4 Configuration Utility Manual

Select to restore factory default settings for Inputs/Outputs Factory Values:
EDIDs for all Inputs: 1080P60, 2 Channel Audio
I/O: All Outputs set to Input 1

13. OTHER SETTINGS

During the installation of a matrix, there are settings that provide Advanced Configuration not available via the
remote control. These allow for fine tuning the matrix when used under certain conditions and the settings listed
below are not available from the remote.

13.2. Front Panel IR Enable

Use this setting to Enable (default) and Disable the front panel IR receiver. This is useful if the matrix is placed
in a location that causes IR flooding from sunlight or other source. This setting only affects the Front Panel IR
Receivers.

13.3. System IR Enable

Use this setting to disable the System IR Input on the back of the matrix.
13.4. Matrix Control from Room Enable
When Set to Yes (default), IR coming from a Room can be used to control the matrix. When set to No, matrix
commands sent from a room will not control the matrix. This setting may be needed if IR flooding from sunlight or
other source is sometimes present in one or more rooms.

13.5. Front Panel Power Button Active

Use this feature to Disable/Enable the front panel power button of the matrix when using an Control System. This
FIGURE 6
12