Receiver Screens & Prompts - Dexcom SEVEN PLUS User Manual

To change the settings for Alerts and
Alerts
notifications from your Receiver, including High, Low,
Out of Range, Rate of Change, and Other Alerts
To change the time and date and
Settings
Transmitter ID number and to look up your SEVEN PLUS'
hardware and software
numbers
Shutdown To temporarily turn off all communications between
your Sensor, Transmitter and Receiver
To end a Sensor wear session early
Stop
• This option only appears in the middle of Sensor use
Sensor
1.5.2 RECEIVER SCREENS & PROMPTS
The following prompt screens may appear on the Receiver during use:
DOUBLE BLOOD DROP PROMPT: Appears about 2 hours after you
insert a new Sensor and tells you that you need to take 2
fingerstick readings on your meter and enter them to calibrate.
SHADED-OUT BLOOD DROP PROMPT: This tells you that only
1 fingerstick reading has been successfully entered. You need to take and enter
at least 1 more fingerstick reading using your
meter for calibration.
SINGLE BLOOD DROP PROMPT: This Screen appears during
Calibration Update or Re-Calibration. This means it is time for you to take a fingerstick on
your BG meter and enter it into the Receiver. But first check the Status Box. Only enter
fingerstick readings if the Status Box shows the Single Blood Drop or a Glucose Reading.
Do not enter any fingerstick readings if there are "???" or "
LOW BATTERY NOTIFICATION: Your Receiver battery is running low and
needs to be recharged. Charge the battery as soon as possible.
NEW METER SCREEN (Auto Upload only): A new OneTouch Ultra
meter has been plugged into your Receiver. This meter has a different serial number
from the meter that was last connected to the Receiver. If you receive this screen
during Auto Upload calibration, you will have to re-take any fingersticks needed for
calibration and then connect the 2 devices again for Calibration Update.
Section 2.3
Section 2.2
Section 5.5
Section 7.2
" in the Status Box.
SEVEN PLUS User's Guide | 25