Table of Contents
Advertisement
PART A - OPERATION AND MAINTENANCE
Please see Part B for installation instructions.
1 SAFETY INFORMATION
1.1 Summary of Operation and Maintenance Cautions and Warnings
HOT WHILE IN OPERATION, KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY
•
CAUSE SKIN BURNS. GLOVES MAY BE NEEDED FOR ZERO CLEARANCE WOOD INBUILT OPERATION.
USING A ZERO CLEARANCE WOOD INBUILT WITH CRACKED OR BROKEN COMPONENTS, SUCH AS
•
GLASS OR FIREBRICKS OR BAFFLES MAY PRODUCE AN UNSAFE CONDITION AND MAY DAMAGE THE
ZERO CLEARANCE WOOD INBUILT.
OPERATE ONLY WITH DOOR FULLY CLOSED. IF DOOR IS LEFT PARTLY OPEN, GAS AND FLAME MAY BE
•
DRAWN OUT OF THE OPENING, CREATING RISKS FROM BOTH FIRE AND SMOKE.
•
OPEN THE AIR CONTROL FULLY BEFORE OPENING THE LOADING DOOR.
•
THIS ZERO CLEARANCE WOOD INBUILT IS NOT DESIGNED TO BE USED WITH THE DOOR OPEN. THE
DOOR MAY BE OPEN ONLY DURING LIGHTING PROCEDURES OR RELOADING. DO NOT LEAVE THE ZERO
CLEARANCE WOOD INBUILT UNATTENDED WHEN THE DOOR IS SLIGHTLY OPENED DURING IGNITION.
ALWAYS CLOSE THE DOOR AFTER IGNITION.
DO NOT INSTALL THE ZERO CLEARANCE WOOD INBUILT OUTDOORS.
•
THE ZERO CLEARANCE WOOD INBUILT AND FLUE SYSTEM MUST BE IN AN ENCLOSURE UP TO THE
•
ATTIC.
NEVER USE GASOLINE, LANTERN FUEL (NAPHTHA), FUEL OIL, MOTOR OIL, KEROSENE, CHARCOAL
•
LIGHTER FLUID, OR SIMILAR LIQUIDS OR AEROSOLS TO START A FIRE IN THIS ZERO CLEARANCE WOOD
INBUILT. KEEP ALL SUCH LIQUIDS OR AEROSOLS WELL AWAY FROM THE ZERO CLEARANCE WOOD
INBUILT WHILE IT IS IN USE.
DO NOT STORE FUEL WITHIN HEATER MINIMUM INSTALLATION CLEARANCES.
•
BURN SEASONED HARDWOOD ONLY.
•
•
DO NOT BURN:
GARBAGE OF ANY KIND,
o
COAL OR CHARCOAL,
o
TREATED, PAINTED OR COATED WOOD,
o
PLYWOOD OR PARTICLE BOARD,
o
FINE PAPER, COLORED PAPER OR
o
CARDBOARD,
THIS APPLIANCE SHOULD BE MAINTAINED AND OPERATED AT ALL TIMES IN ACCORDANCE WITH
•
THESE INSTRUCTIONS.
DO NOT ELEVATE THE FIRE BY MEANS OF GRATES, AND IRONS OR OTHER MEANS.
•
CAUTION:
DO NOT OBSTRUCT AIR INLETS. THIS ZERO CLEARANCE WOOD INBUILT NEEDS AIR FOR ITS
GOOD OPERATION.
CAUTION:
DO NOT BLOCK THE HOT AIR VENTS TO THE ZERO CLEARANCE WOOD INBUILT AS THIS WILL
CAUSE THE ZERO CLEARANCE WOOD INBUILT TO OVERHEAT.
WARNING:
DO NOT USE MATERIALS OTHER THAN THOSE LISTED IN THE REPLACEMENT PARTS
SECTION DURING INSTALLATION AS THEY MAY BE SAFETY HAZARDS AND A FIRE COULD
RESULT.
OPERATING & INSTALLATION INSTRUCTIONS FOR STRATFORD CF ZERO CLEARANCE WOOD HEATER
SALT WATER DRIFTWOOD,
o
MANUFACTURED LOGS CONTAINING WAX OR
o
CHEMICAL ADDITIVES,
RAILROAD TIES OR
o
LIQUIDS SUCH AS KEROSCENE OR DIESEL FUEL
o
TO START A FIRE.
5
Advertisement
Table of Contents
