Table of Contents
Advertisement
CONNECT THIS WOOD FIRE ONLY TO A TRIPLE SKIN FLUE SYSTEM AS PER AS/NZS 2918, APPENDIX B,
•
OR ANY FLUE SYSTEM TESTED TO AND PAST THE REQUIREMENTS OF AS/NZS 2918, APPENDIX F, FOR
USE WITH SOLID FUEL.
IF REQUIRED, A SUPPLY OF COMBUSTION AIR SHALL BE PROVIDED TO THE ROOM.
•
CONNECT ONLY TO MANDATORY HOT AIR GRAVITY KIT – MODERN STYLE WITH ADJUSTABLE PIPES
•
(AC01389). DO NOT CONNECT TO OR USE IN CONJUNCTION WITH ANY AIR DISTRIBUTION DUCTWORK
UNLESS SPECIFICALLY APPROVED WITH THE APPLIANCE.
DO NOT CONNECT THIS UNIT TO A FLUE SERVING ANOTHER APPLIANCE.
•
THIS ZERO CLEARANCE WOOD INBUILT HAS NOT BEEN TESTED TO BE INSTALLED INSIDE A MASONRY
•
CHIMNEY.
6.2 Regulations Covering Zero Clearance Wood Inbuilt Installation
When installed and operated as described in these instructions, the Stratford CF zero clearance wood
inbuilt is suitable for use in residential installations. The Stratford CF zero clearance wood inbuilt is not
intended for installation in a bedroom.
NOTE:
The Zero clearance wood inbuilt is not approved for use with a so-called "positive flue connection"
to the clay tile of a masonry flue system.
STRATFORD CF ZERO CLEARANCE WOOD INBUILT SHOULD BE INSTALLED ONLY BY A LICENSED
ACCREDITED INSTALLER. PLEASE REFER TO YOUR RETAILER TO LOCATE AN INSTALLER.
FAILURE TO USE AN AUTHORIZED INSTALLER MAY VOID YOUR HOME & CONTENTS INSURANCE POLICIES.
28
OPERATING & INSTALLATION INSTRUCTIONS FOR STRATFORD CF ZERO CLEARANCE WOOD HEATER
Advertisement
Table of Contents
