Table of Contents
Advertisement
The gasket must be centred on the edge of the glass. To do this easily, peel back a section of the paper
covering the adhesive and place the gasket on a table with the adhesive side up. Stick the end of the gasket
to the middle of top edge of the glass, then press the edge of the glass down onto the gasket, taking care
that it is perfectly centred on the gasket. Peel off more of the backing and press the whole length of the
edge of the glass onto the gasket. Do not stretch the gasket as you place it. Cut to the necessary length.
Now pinch the gasket to the glass in a U shape over the front and back of the glass. Do the same for the
bottom edge of the glass.
Location
Around glass
Backside
Another glass gasket is located at the back of the glass. When replacing the glass or as needed, install
according to following illustrations.
Reinstall the glass, being careful to centre the glass carefully in the door. Do not over-tighten the screws.
Note that the two main causes of broken door glass are uneven placement in the door and over-tightening
of retaining screws.
Do not abuse the glass door by striking or slamming shut. Do not use the fireplace if the glass is broken. To
change the glass, perform the same operation described above.
24
OPERATING & INSTALLATION INSTRUCTIONS FOR STRATFORD CF ZERO CLEARANCE WOOD HEATER
Length
79 cm (2X)
229 cm
Dimensions
"U" shaped self adhesive
Flat, self-adhesive 3 mm x 25 mm
Advertisement
Table of Contents
