18 FITTING THE THERMOCORD
(This may be conducted before Frame 16 with the sections laid
flat on the floor)
1. Put a drop of silicone at about every 200mm of the groove.
200 mm
19 ASSEMBLING THE INTERMEDIATE SECTIONS
1. Place the first intermediate section onto the
base frame.
2. Fit the connections of the intermediate section
onto the nipples in the rear section.
3. Ensure that the thermocord fits evenly between
the sections in the correct manner to make a
good seal.
4. Hammer in with the help of a small wooden
block.
5. Insert the assembly tool through the nipples
and tighten.
14
INSTALLATION
2. Working from point A, insert the thermocord into the groove.
3. Cut it to the correct length
4. Repeat for intermediate sections.
1
1
4
4
3
5
5
Harrier GTS -
thermocord
2
A
3
2
1
Installation & Servicing