IDEAL Harrier GTS 5 Installation And Servicing page 19

26 FITTING THE THERMOSTAT SENSOR POCKET AND PLUGGING THE
UNUSED TAPPING
1. Apply some thread sealing tape or
compound to the sensor pocket,
reducing bush and bottom tapping
plug.
2. Screw the threaded bush with the
sensor pocket into the upper
connection and the plug into the
lower connection.
27 FITTING THE SMOKEHOOD
1. Screw the four M8 studs into the rear section.
2. Put a drop of silicone at about every 100mm of the
groove.
3. Insert the thermocord into the groove.
4. Cut it to the correct length.
5. Assemble the smokehood onto the studs and
secure with four flanged M8 nuts.
3
Harrier GTS -
Installation & Servicing
INSTALLATION
4
2
2
2
5
M8
M8
M8
M8
1
1
4x
M8
19