IDEAL Harrier GTS 5 Installation And Servicing page 13

16 POSITIONING THE REAR SECTION
1. Place the rear section in its
required position and support with
a wooden block.
2. Position the base frame up to the
rear section and insert the two
lower tie rods.
3. Slide the spacer over the rear end
of the threaded tie rod before
passing it through the rear section
4. Pass the rods through the rear
section and secure both ends with
the 4 washers and M12 nuts.
(This may be conducted after
preparing the section (Frame 17)
and fitting thermocord (Frame 18) if
preferred.)
17 PREPARING THE REAR SECTION
(This may be conducted before Frame 16 with the section laid flat
on the floor.)
1. Clean the nipple ports and nipples with cleaning fluid.
2. Coat the nipples with the coating material supplied.
3. Push in the two nipples moderately.
4. Gently tap in the nipples using a wooden block to avoid
damage.
Harrier GTS -
Installation & Servicing
INSTALLATION
4
2
3
3
1
M12
4
3
2
M12
M12
2
4
1
1
4
4
13