IDEAL Harrier GTS 5 Installation And Servicing page 23

31 INSTALLING THE CASING CROSSBAR SUPPORTS
1. Fit four edge clips to the crossbars.
2. Secure the crossbars to the front and rear
section lugs using the M12 bolts, washers,
shakeproof washers and nuts. (Note the
direction of the crossbar to ensure the edge
clips fit from the front.)
32 INSTALLING THE MAINS AND SENSOR CABLE TRAYS
1. Slide the trays into the casing crossbar
supports.
2. Lower the front plate into position on the
trays.
3. Secure the front plate with screws at each
side.
4. Slide the assembly towards the rear until the
front plate meets the crossbar.
5. Secure the trays with four edge clips.
5
Harrier GTS -
Installation & Servicing
INSTALLATION
1
M12
2
3
5
5
4
1
M12
1
1
1
2
M12
2
M12
2
2
1
3
23