IDEAL Logic Heat 12 User Manual
Hide thumbs
Also See for Logic Heat 12:
- Installation and servicing (72 pages) ,
- User manual (6 pages) ,
- Pocket manual (73 pages)
Table of Contents
Advertisement
USERS GUIDE
LOGIC Heat
12, 15, 18, 24, 30
For installation guide see reverse of book
When replacing any part on this appliance, use only spare parts that you can be
assured conform to the safety and performance specification that we require.
Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.
Advertisement
Table of Contents
Related Manuals for IDEAL Logic Heat 12
Summary of Contents for IDEAL Logic Heat 12
-
Page 1: Users Guide
When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and performance specification that we require. Do not use reconditioned or copy parts that have not been clearly authorised by Ideal. -
Page 2: Reset
Benchmark Commissioning Checklist. You can check your installer by calling Gas Safe Register direct on 0800 4085500. Ideal stelrad group is a member of the Benchmark scheme and fully supports the aims of the programme. Benchmark has been introduced to improve the standards of installation and commissioning of central heating systems in the UK and to encourage the regular servicing of all central heating systems to ensure safety and efficiency. -
Page 3: Frost Protection
Condensate Drain The condensate drain (F) must not be modified or blocked. boiler conTrols Legend a. Temperature Control C. Boiler Status E. Condensate Drain B. Mode Control D. Burner ‘on’ Indicator F. Economy Mode 205862-10089 205862-10090 Ideal Logic Heat - User’s... -
Page 4: Troubleshooting
The boiler has a call for heating but the appliance has reached the desired temperature set on the boiler. The boiler is operating in heating mode. The boiler is operating in frost mode. continued ..Ideal Logic Heat - User’s... -
Page 5: Fault Codes
Check system pressure is between 1 & 1.5bar on the pressure gauge. Flow Temperature Overheat If the boiler fails to operate then please contact Ideal (if under warranty) or alternatively a Gas Safe Registered Engineer if outside of the Unconfigured PCB warranty period. - Page 8 Ideal stelrad group pursues a policy of continuing improvement in the design and performance Ideal Consumer Helpline of its products. The right is therefore reserved to vary specification without notice. Tel: 01482 498660 Ideal, P.O. Box 103, National Ave, Kingston Upon Hull, HU5 4JN.