Table of Contents
Advertisement
7. Firmware and RAIDWatch: The overall status of the system may be
checked using the pre-installed firmware or the RAIDWatch GUI.
8. Audible alarm: If any errors occur during the initialization process, the
onboard alarm will sound in a hastily repeated manner.
9. Drive tray LEDs should start flashing, indicating that the RAID control
units are attempting to access the hard drives.
System firmware can be configured to support a delayed sequence for
starting drives. Please consult your Fibre to SATA RAID Subsystem
Operation Manual for more details.
The subsystem has been designed to run continuously. If a component
fails, the fault can be corrected online.
4.5.4 LCD Screen
When powering on the subsystem, wait for the front panel LCD screen to
show "READY" or "No Host LUN" before the host boots up. Refer to
Figure 4-8 on how to read the screens.
The LCD screen startup sequence is shown and described in the sequence
below:
Initializing....
Please Wait...
A16F-R2422
Power On Self-Test
A16F-R2422
Self-Test Completed
Subsystem Connection and Operation
Chapter 4: Subsystem Connection and Operation
NOTE:
Model Name
A16F-R2422
Ready
Status/Data Transfer Indicator
Figure 4-8: The LCD Startup Screen
Primary/Secondary Controller
P/S
This screen appears when the PSUs are
turned on.
The subsystem will start a self-test.
The self-test has been completed.
4-15
Advertisement
Table of Contents
