Lcd Screen - Rorke Data Galaxy 16i User Manual

1. Controller Module LEDs – The controller ready, FC Host
Ports Active, SATA Device Ports Active LEDs should all flash
green.
2. Drive Tray LEDs – The Green LED for all the drive trays
(that contain hard drives) should light up showing that there is
power.
3. LCD Panel LEDs – The blue LED on the LCD panel should
come on indicating that power is being supplied to the
system.
4. Firmware and RAIDWatch – The overall status of the
system may be checked using the pre-installed firmware or
the RAIDWatch GUI.
5. Audible Alarm - If any errors should occur during the
initialization process, the onboard alarm should be sounded in
a hastily repeated manner.
Drive tray LEDs should normally start flashing, indicating the
RAID control units are attempting to access the hard drives.
System firmware supports configuration of a delayed sequence for
starting drives. Please consult your Generic Operation Manual for
more details.
NOTE:
The subsystem has been designed to run continuously. Even if a
component failure occurs the fault can be corrected online.

4.8.5 LCD Screen

When Powering On the subsystem the following messages should
appear on the front panel LCD screen. Wait for the front panel
LCD to show "READY" or "No Host LUN" before the host
boots up. Refer to Figure 4- 12 on how to read the screens.
4-16
Indicates Firmware version
Galaxy 16i User's Manual