Table of Contents
Advertisement
Galaxy A16F-R2422 Installation and Hardware Reference Manual
2.8 Drive Tray Installation
Once the hard drives have been installed in the drive trays, the drive trays
can be installed into the A16F-R2422.
All drive trays must be installed into the enclosure even if they do not
contain a hard drive. If the trays are not installed into the enclosure, the
ventilation required for cooling will not be normalized and the subsystem
will overheat.
Step 1. Make sure the key-lock is in the unlocked position, i.e., the groove on
its face is in a horizontal orientation as shown in Figure 2-5. If the
groove is in a vertical position, then the key-lock is locked and the front
flap on the drive tray cannot be opened.
Step 2. Open the front flap on the drive tray (see Figure 2-6) by pushing the
release button on the front of the drive tray. The front flap will open in
an upward direction.
Step 3. Align the drive tray with the slot in which you wish to insert it. Make
sure that it is resting on the rails inside the enclosure, and then gently
slide it in. This should be done smoothly and gently. (See Figure 2-7)
2-8
WARNING!
Figure 2-5: Front View of an Individual Drive Tray
Figure 2-6: Opening the Drive Tray Front Flap
Hardware Installation
Advertisement
Table of Contents
