Table of Contents
Advertisement
Galaxy A16F-R2422 Installation and Hardware Reference Manual
drive bays, accommodate SATA-II hard drives (backward compatible to
SATA-I).
Two (2) redundant, hot-swappable, dual-fan cooling modules protect the
subsystem from overheating and two (2) redundant, hot-swappable, 2U
460W power supply units (PSUs) provide constant power to the subsystem.
The modular nature of the subsystem and the easy accessibility to all major
components ensure the ease of the subsystem maintenance.
On receiving and unpacking your subsystem, please check the package
contents against the included Unpacking Checklist. If any modules are
missing, please contact your subsystem vendor immediately.
1.1.2
1.1.2.1 Chassis Overview
The A16F-R2422 RAID storage subsystem chassis is an enhanced 3U metal
chassis divided into front and rear sections, which are respectively accessed
through front (see Figure 1-3) and rear (see Figure 1-5) panels. Pre-drilled
mounting holes in the sides of the 3U RAID subsystem enclosure allow you
to attach separately purchased slide rails so that you can install the enclosure
into a rack or cabinet. Please see Figure 1-2 for the components' locations
in the subsystem and read the following sections for the front and rear
panels descriptions.
1-2
NOTE:
Enclosure Chassis
Figure 1-2: A16F-R2422 Subsystem Overview
Introduction
Advertisement
Table of Contents
