Installation; Chassis Placement - Pacific Power Source ASX series Operation Manual

3

INSTALLATION

This section describes the installation of the ASX-Series AC Power Source.
3.1

CHASSIS PLACEMENT

The ASX-Series Power Source is designed to fit into the standard 19 inch rack. Provisions for
mounting slide rails are included in most chassis. The ASX can also be used as a bench-top unit,
if desired.
(VARIOUS MODELS WEIGH APPROX 70-244 lbs. [32-111kg] PER ASSY)
THE MAGNETICS MODULES, MODELS 140-ASX, AND 345-ASX THROUGH 3120-ASX
UNIT MUST BE LIFTED BY TWO OR MORE INDIVIDUALS IN ORDER TO REDUCE
It is the customer's responsibility to insure that units are adequately
packaged when they are moved to a different location. The units should
always be packaged in the original shipping container when moved or
returned to the factory for service.
SECTION 3
INSTALLATION
THE ASX-SERIES CHASSIS IS HEAVY!
USE EXTREME CARE WHEN MOVING THE UNIT.
ARE NOT A ONE-PERSON LIFT.
CHANCE OF PHYSICAL INJURY.
- - - - - - - - P A C K I N G N O T I C E - - - - - -
- - - - - - - - P A C K I N G N O T I C E - - - - - -
34
WARNING