Specifications; Electrical Specifications; Input Power Requirements - Pacific Power Source ASX series Operation Manual

2

SPECIFICATIONS

This section states the electrical specifications of the ASX-Series Power Source.
specifications listed apply to all models, except as noted. Some specifications are controller
dependent. These are noted as such.
2.1

ELECTRICAL SPECIFICATIONS

2.1.1 INPUT POWER REQUIREMENTS

This paragraph lists and defines the input voltage forms that are accepted by the various models
within the ASX-Series line of equipment.
appropriate model when determining proper input service requirements. The input currents
listed are those for operation at full rated load. Overload conditions will result in higher input
currents that still fall within the recommended input service.
The input power transformer of the ASX-Series Power Source has taps for each of the listed
power forms--one of which is selected by the factory at time of order. Once selected, the unit will
operate at designated voltage, ±10%.
The standard input frequency of 50/60 Hz is offered for all models. 400 Hz ( 360 – 440 Hz) option
is also available. Please call factory for details.
INPUT VOLTAGE
The Model 115-ASX accepts one of the following single phase input voltages:
1)
2)
3)
4)
5)
6)
7)
8)
INPUT CURRENT
The input current required by the Model 115-ASX at full rated load is stated below.
Recommended input service is also stated.
1)
2)
3)
4)
5)
6)
7)
8)
SECTION 2
SPECIFICATIONS
MODEL 115-ASX
100 VAC ±10%, 47-63 Hz
110 VAC ±10%, 47-63 Hz
120 VAC ±10%, 47-63 Hz
200 VAC ±10%, 47-63 Hz
208 VAC ±10%, 47-63 Hz
220 VAC ±10%, 47-63 Hz
230 VAC ±10%, 47-63 Hz
240 VAC ±10%, 47-63 Hz
V INPUT CURRENT
in
100 VAC 22 A
110 VAC 20 A
120 VAC 18 A
200 VAC 11 A
208 VAC 10 A
220 VAC 10 A
230 VAC 9 A
240 VAC 9 A
Each model is listed separately. Refer to the
SERVICE RECOMMENDED
rms
rms
rms
rms
rms
rms
rms
rms
7
25 A
25 A
25 A
15 A
15 A
15 A
15 A
15 A
The