Figure 4.6.1 Asx-Series System Architecture - Pacific Power Source ASX series Operation Manual

SECTION 4 OPERATION
4.6.1 SYSTEM ARCHITECTURE (cont.)
The three phase output systems can be used as 1 or 2 phase systems. This is accomplished by
setting the controller for the appropriate output form and then connecting the load accordingly.
Systems which contain a UPC-Series programmable controller have the ability to change output
form via commands.
It should be noted that most ASX-Series Power Sources may be configured with transformer
outputs, and are therefore dual-range. Selection of the appropriate output range, direct or
transformer-coupled, is via commands issued by the controller.

FIGURE 4.6.1 ASX-SERIES SYSTEM ARCHITECTURE

80