Installation; Chassis Placement - Pacific Power Source AMX Series Operation Manual

3.0

INSTALLATION

This section describes the installation of the AMX-Series AC Power Source.
NOTE: ETL LABELED UNITS ONLY
For models 105,108,112,305,308,312 and 320-AMX, an input power cord plug is
provided to meet ETL safety standard requirement.
For models 125,140, 345,360,390 and 3120-AMX, the input terminal block cover
is provided to meet ETL safety standard requirement. Use of the cover is
mandatory and "Knock-outs" are provided for wiring to the input terminal block.
3.1

CHASSIS PLACEMENT

The AMX-Series Power Source is designed to fit into a standard 19 inch rack. Provisions for
mounting slide rails are included in the chassis. The power source can also be used as a
bench-top unit, if desired.
(VARIOUS MODELS WEIGH APPROX 70-195 lbs PER ASSY)
THE MAGNETICS MODULE, MODELS 125-AMX, 140-AMX, 160-AMX AND
320-AMX THROUGH 3120-AMX ARE NOT A ONE-PERSON LIFT,
AND MUST BE LIFTED BY TWO OR MORE INDIVIDUALS IN ORDER TO REDUCE
IT IS THE CUSTOMER'S RESPONSIBILITY TO ENSURE THAT
UNITS ARE ADEQUATELY PACKAGED WHEN THEY ARE
MOVED TO A DIFFERENT LOCATION.
ALWAYS
CONTAINER WHEN MOVED OR RETURNED TO THE FACTORY
FOR SERVICE.
CHASSIS DAMAGE--INCURRING NON-WARRANTY SERVICE
COSTS.
SECTION 3
INSTALLATION
AMX-SERIES POWER SOURCES ARE HEAVY !
USE EXTREME CARE WHEN MOVING THE UNIT.
CHANCE OF PHYSICAL INJURY.
- - - - - - - - P A C K I N G N O T I C E - - - - - -
BE PACKAGED
INADEQUATE PACKAGING WILL RESULT IN
- - - - - - - - P A C K I N G N O T I C E - - - - - -
WARNING
THE UNITS SHOULD
IN THE ORIGINAL
41
SHIPPING