Operation; Front Panel Controls - Pacific Power Source ASX series Operation Manual

4

OPERATION

This section describes the operation of an ASX-Series AC Power Source.
described in the following paragraphs is a general procedure common to all systems (except as
noted). This procedure does not detail operation of a specific controller. Refer to the appropriate
controller manual for detailed information regarding the installed controller.
4.1

FRONT PANEL CONTROLS

This paragraph shows the location of the front panel controls and indicators of the ASX-Series
Power Source. A brief description of each is also given. Figure 4.1 is a front view of the Model
360-ASX with a UPC-3 controller installed. The front panel control section is similar in all
ASX-Series models. Refer to the UPC-Series OPERATION MANUAL or Section 8 of this manual
for information relative to the installed controller.
1. INPUT POWER SWITCH (Circuit Breaker)
Circuit Breaker used as the main input ON/OFF control and protects the power source
from drawing excessive input current from the input AC line.
2. OUTPUT POWER SWITCH and INDICATORS
Switch used to control the output contactor of the ASX-Series Power Source. Indicators
show the state of the output contactor. The power source will enter shutdown for the case
of over-temperature or other internal fault. Shutdown is reset when the Output Power
Switch is set to OFF and the fault has cleared. (Switch not present on SCU.) Refer to
Paragraph 4.5 for details.
3. OUTPUT COUPLING INDICATORS
LED's which show the Output Coupling of the power source.
4. OUTPUT FORM INDICATORS
LED's which show the Output Form that is active. (The Model 115-ASX is a Single Phase
output system and has no Phase indicators. The 3 Phase indicator is not present on the
Models 120-ASX and 140-ASX.)
SECTION 4
OPERATION
73
The procedure