Calibration; Calibration Interval; Test Equipment Requirements - Pacific Power Source ASX series Operation Manual

6

CALIBRATION

This section describes the calibration of the ASX-Series AC Power Source.
6.1

CALIBRATION INTERVAL

The ASX-Series Power Source requires calibration once every six months or after service has
been performed to the system.
6.2

TEST EQUIPMENT REQUIREMENTS

The test equipment listed below is required for calibration of the ASX-Series Power Source.
1.
2.
3.
4.
5.
Current requirement
10A/1φ
10A/1φ
26A/1φ
40A/1φ
10A/1φ
10A/1φ
30A/1φ
40A/1φ
80A/1φ
SECTION 6
CALIBRATION
Digital Voltmeter:
Frequency counter:
Digital Ammeter: 3½ Digit True-RMS responding 5000 Hz bandwidth, min.
(Alternate Approach: Current transformer used in conjunction with the DVM.)
Oscilloscope:
Load (Resistive):
5A/φ - 2φ
13A/φ - 2φ
13.3A/φ - 2φ
3.3A/φ - 3φ
3.3A/φ - 3φ
10A/φ - 3φ
13.3A/φ - 3φ
26A/φ 3φ
4½ Digit True-RMS responding 5000 Hz bandwidth, min.
5 digit counter, min.
(Optional)
Varies by model number
@ Voltage Model Name
@ 132 VAC Model 115-ASX
l-n
@ 150 VAC Model 120-ASX
l-n
@ 135 VAC Model 140-ASX
l-n
@ 132 VAC Model 160-ASX
l-n
@ 132 VAC Model 315-ASX
l-n
@ 150 VAC Model 320-ASX
l-n
@ 135 VAC Model 345-ASX
l-n
@ 132 VAC Model 360-ASX
l-n
@ 135 VAC Model 3120-ASX
l-n
82