Specifications; Electrical Specifications; Input Power Requirements - Pacific Power Source AMX Series Operation Manual

2.0

SPECIFICATIONS

This section states the electrical specifications of the AMX-Series Power Source.
specifications listed apply to all models, except as noted. Some specifications are controller
dependent. These are noted as such.
2.1

ELECTRICAL SPECIFICATIONS

2.1.1 INPUT POWER REQUIREMENTS

This paragraph lists and defines the input voltage forms that are accepted by the various
models within the AMX-Series line of equipment. Each model is listed separately. Refer to
the appropriate model when determining proper input service requirements.
currents listed are for operation at full rated load. Overload conditions will result in higher
input currents that still fall within the recommended input service.
The input power transformer of the AMX-Series Power Source has taps for each of the listed
power forms - one of which is selected by the factory at time of order. Once selected, the
unit will operate at designated voltage, ±10%.
INPUT VOLTAGE AND INPUT CURRENT
The Model 105-AMX single phase input voltages, required input currents at full rated load and
recommended service input currents are stated as below.
1) 100 VAC ±10%, 47-63 Hz
2) 110 VAC ±10%, 47-63 Hz
3) 120 VAC ±10%, 47-63 Hz
4) 200 VAC ±10%, 47-63 Hz
5) 208 VAC ±10%, 47-63 Hz
6) 220 VAC ±10%, 47-63 Hz
7) 230 VAC ±10%, 47-63 Hz
8) 240 VAC ±10%, 47-63 Hz
SECTION 2
SPECIFICATIONS
MODEL 105-AMX
INPUT VOLTAGE
(360-440 Hz optional)
INPUT
CURRENT RECOMMENDED
12 A
rms
12 A
rms
11 A
rms
6 A
rms
6 A
rms
6 A
rms
6 A
rms
6 A
rms
7
The
The input
SERVICE
25 A
25 A
25 A
15 A
15 A
15 A
15 A
15 A