User Subscription/Unsubscription; System Id - iPECS eMG80 Installation Manual

iPECS eMG80
System DECT Installation Guide

3.6 User Subscription/Unsubscription

3.6.1 System ID

A System ID is given to iPECS eMG80 system attached to the wireless terminal for identification.
System ID, which is the Potable Access Rights Key (PARK), is written on the KSU.
The Authentication Code as well as System ID should be entered at only the Attendant Station
before subscribing the wireless terminal to iPECS eMG80 system.
To display the System ID, perform the following Steps:
1. From the Attendant station, press [TRANS/PGM] button.
2. Dial 0#.
3. Press the FLEX 4 button.
When modifying or entering the System ID:
1. From the Attendant Station, press [TRANS/PGM] button.
2. Dial 0#.
3. Press the FLEX 6 button.
4. Enter the System ID (PARK code, refer to key sequence description below).
5. When finished, press the [HOLD/SAVE] button; a confirmation tone will be heard.
Normally you should not change the system ID. If you should change it, please
contact Ericsson-LG Enterprise or the local dealer in your country.
The key sequence of the PARK= LLP__________PC

LL – Two digits decimal representation of PARK length (Bit count)

P______P – 11 heximal digits representation of PARK

C – Check digit, calculated as the sum of each digit in the input stream multiplied by
its position in the input stream, module of 11; if the result is 10, this is represented by *.
Conditions
1. The System ID must be programmed when the System is installed.
2. When System ID is programmed, all previously entered data related to wireless features
will be erased.
3. The initial PARK value is 00000000000000; the value will display in LCD at first.
CAUTION
23
Issue 1.3