Regulatory Information - iPECS eMG80 Installation Manual

iPECS eMG80
System DECT Installation Guide
Before making connections to the telephone network, you may be required to notify your local
serving telephone company of your intention to use "customer provided equipment." You may
further be required to provide any or all of the following information:
PSTN line Telephone numbers to be connected to the system
Model name
The required regulatory agency registration number is available from your local Ericsson-LG
Enterprise representative.
This equipment complies with the following regulatory standards, EN 301, EN 406, TBR 10 and
TBR 22. Also, this equipment complies with the safety requirements of EN 60950-1 and the EMC
requirements of EN5022, EN5024, EN301 489-1 and EN 301 489-6.
GDC-450/500H has been designed to comply with the Hearing Aid Compatibility requirements as
defined in Section 68.316 of Part 68 FCC Rules.
If the telephone company determines that customer provided equipment is faulty and may
possibly cause harm or interruption in service to the telephone network, it should be disconnected
until repair can be affected. If this is not done, the telephone company may temporarily
disconnect your service.
The local telephone company may make changes in its communications facilities or procedures.
If these changes could reasonably be expected to affect the use of iPECS eMG80 or compatibility
with the network, the telephone company is required to give advanced written notice to the user,
allowing the user to take appropriate steps to maintain telephone service.
iPECS eMG80 complies with rules regarding radiation and radio frequency emission as defined
by local regulatory agencies. In accordance with these agencies, you may be required to provide
information such as the following to the end user:
"This equipment generates and uses R.F. energy, and if not installed and used in
accordance with the Instruction Manual, it may cause interference to radio
communications. It has been tested and found to comply with the appropriate limits for a
telecommunication device. The limits are designed to provide reasonable protection
against such interference, when operated in a commercial environment. Operation of this
equipment in a residential area could cause interference, in which case the user, at his
own expense, will be required to take whatever measures may be required to correct the
interference."

Regulatory Information

WARNING
Issue 1.3
iPECS eMG80 DECT