p
reparIng for
WarnInG:
•
If the gas or electric service provided does not meet the
product specifications, do not proceed with the installation.
Call the dealer, the gas supplier, or a licensed electrician.
•
Before installing the range, you must locate and secure the
anti-tip bracket to the floor.
IMPorTanT: Within the Commonwealth of Massachusetts, this
appliance must be installed by a licensed plumber or gas fitter.
unpack the range
Unpack the parts box and verify that all required components
have been provided. If any item is missing or damaged, please
contact your dealer immediately. Do not install a damaged or
incomplete appliance.
Parts List
◊
3 Grates
◊
2 Small Stack Burner Caps
◊
2 Small Stack Burner Rings
◊
2 Large Stack Burner Caps
◊
2 Crown Burner Caps
◊
2 Crown Burner Rings
◊
2 Crown Burner Heads
◊
1 GlideRack
◊
2 Standard Size Racks
◊
3 18" Racks
(ER48D only)
WarnInG: Be sure that the unit is not connected to gas or
power before proceeding with the following sections:
Level and adjust the range height
1.
Raise or lower the range until it is the same height as the
counter-top. To adjust the height, turn the foot on the bottom
of each leg as shown below.
2.
Use a level to make sure that the range does not tilt front to
back or side to side. Readjust the legs if necessary.
Back of range
anti-Tip Foot
(location varies)
I
nsTallaTIon
I
nsTallaTIon
WarnInG
◊
6 Knobs
◊
Anti-tip Bracket w/Screws
◊
Meat Probe
◊
Griddle
◊
Wok Ring
◊
Spatula
◊
Stainless Steel Cleaner
◊
Pry Stick
◊
Literature Kit
◊
Ignitor Cleaning Kit
◊
Broiler Pan/Grill
WarnInG
rear Leg
down
1 1/4"
up
I
nsTruCTIons
Install the anti-Tip Bracket and Foot
1.
Locate the anti-tip foot and lower it until it is 1/16" (2mm) off
the floor. See the bottom left diagram.
2.
Locate the anti-tip bracket included in the parts box.
3.
Install the anti-tip bracket on the floor using the four included
screws. The mounting location varies according to the model.
See the diagram below for location.
range
Left Side
Panel
anTI-TIP BracKeT PLaceMenT
Dimension
"G"
"H"
Back of range
Top view
er36D
er48D
7 3/16"
19"
(183mm)
(483mm)
6 3/4"
6 1/4"
(171mm)
(159mm)