Klauke EKP 1 Instruction Manual page 33

Instruction manual EKP 1
_______________________________________________________________________________________________________________________
5.5 Remarks on the use of the battery cartridge and charging unit.
The charging unit type LG4F is run with a nominal voltage of 230 V and a frequency of 50-60
Hz. New batteries must be charged prior to use. To remove the battery RAM 2 actuate the
battery lock (Pos.-No. 6, picture 3 Pos. C) and pull it out of the tool. To charge the battery
(Pos.-No. 7) connect the power plug of the charging unit with the power supply and slide the
battery into the charging unit. The colour of the LED changes from green to red and the
charging cycle begins. The charging time is 40 minutes. The charging level of the battery
cartridge can be checked by a LED.
green battery cartridge is charged
red Battery cartridge is empty and is just being charged
flashing battery cartridge is not pushed in properly or too hot.
The LED is constantly indicating during the charging cycle. When the colour of the LED
changes from red to green the charging cycle is terminated. Afterwards disconnect the charging
unit from the power source.
Is the nominal capacity of the battery not achieved, e.g. at first charge, so the battery is not
necessarily faulty. The full capacity can be achieved after 3 charging/decharging cycles.
Do not charge the battery cartridge in presence of flammable liquids or gases.
If you leave the battery cartridge in the charger to prevent spontaneous discharging after full
charge, the charger will switch into its "trickle charge (maintenance charge)" mode and keep
the battery cartridge fresh and fully charged.
Instruction manual EKP 1
__________________________________________________________________________________________________________________
5.5 Remarks on the use of the battery cartridge and charging unit.
The charging unit type LG4F is run with a nominal voltage of 230 V and a frequency of 50-60
Hz. New batteries must be charged prior to use. To remove the battery RAM 2 actuate the
battery lock (Pos.-No. 6, picture 3 Pos. C) and pull it out of the tool. To charge the battery
(Pos.-No. 7) connect the power plug of the charging unit with the power supply and slide the
battery into the charging unit. The colour of the LED changes from green to red and the
charging cycle begins. The charging time is 40 minutes. The charging level of the battery
cartridge can be checked by a LED.
green battery cartridge is charged
red Battery cartridge is empty and is just being charged
flashing battery cartridge is not pushed in properly or too hot.
The LED is constantly indicating during the charging cycle. When the colour of the LED
changes from red to green the charging cycle is terminated. Afterwards disconnect the charging
unit from the power source.
Is the nominal capacity of the battery not achieved, e.g. at first charge, so the battery is not
necessarily faulty. The full capacity can be achieved after 3 charging/decharging cycles.
Do not charge the battery cartridge in presence of flammable liquids or gases.
If you leave the battery cartridge in the charger to prevent spontaneous discharging after full
charge, the charger will switch into its "trickle charge (maintenance charge)" mode and keep
the battery cartridge fresh and fully charged.
page 33
page 33