Klauke EKP 1 Instruction Manual page 35

Instruction manual EKP 1
_______________________________________________________________________________________________________________________
5.6. Storage and transport
In order to protect the tool against damages it has to be cleaned carefully after every use and be
put into the transportation case which has to be closed safely. Into this plastic carrying case you
accommodate besides the crimping tool the charging unit, 13 sets of tool heads and the
instruction manual.
5.7. Reference as to which spare parts can be exchanged by the customer
Within the determined use of the tool only the tool heads (Pos.-No. 4) and the battery (Pos.-No.
5) are permitted to be changed by the customer.
6. Troubleshooting
a.) Constant flashing of the light diode display (Pos.-#. 8) at the end of a pressing cycle.
=> Service due. Please send the tool to your nearst Authorized Service Center (ASC).
(Pls. See also chapter 4.3 for more information)
b.) The tool loses oil.
=> Return the tool to the manufacturer. Do not open it and damage the seals of the tool.
c.) The pressing tool does not reach the final operating pressure.
=> Stop the crimping process. Actuate the retract slide (Pos.-No. 2) and the operating
switch continuously and simultaneously for about 10 sec. Is the malfunction not be
eliminated by this attempt the tool has to be returned to the manufacturer.
Instruction manual EKP 1
__________________________________________________________________________________________________________________
5.6. Storage and transport
In order to protect the tool against damages it has to be cleaned carefully after every use and be
put into the transportation case which has to be closed safely. Into this plastic carrying case you
accommodate besides the crimping tool the charging unit, 13 sets of tool heads and the
instruction manual.
5.7. Reference as to which spare parts can be exchanged by the customer
Within the determined use of the tool only the tool heads (Pos.-No. 4) and the battery (Pos.-No.
5) are permitted to be changed by the customer.
6. Troubleshooting
a.) Constant flashing of the light diode display (Pos.-#. 8) at the end of a pressing cycle.
=> Service due. Please send the tool to your nearst Authorized Service Center (ASC).
(Pls. See also chapter 4.3 for more information)
b.) The tool loses oil.
=> Return the tool to the manufacturer. Do not open it and damage the seals of the tool.
c.) The pressing tool does not reach the final operating pressure.
=> Stop the crimping process. Actuate the retract slide (Pos.-No. 2) and the operating
switch continuously and simultaneously for about 10 sec. Is the malfunction not be
eliminated by this attempt the tool has to be returned to the manufacturer.
page 35
page 35