Table of Contents
Advertisement
If you have configured line and extension keys (elmeg CS300 only) you can also carry out
Broker's calls between different callers using these keys.
Additional information about the corresponding connections is displayed when you
press the shift key and the softkeys below »conn1«, »conn2«, »conn3« or »conn4«.
To terminate an active connection, press
previously put on hold.
Three-party conference
If you have an active connection and a connection on hold at your system telephone,
you can initiate a conference call with these two parties. All three parties can speak to
one another.
Conference calls are not possible with more than two (2) connections at your phone.
>
g
Call with sub-
scriber 1
To end the three-party conference, press the softkey below »back_to_«. You are re-
connected with the subscriber of the last previous active connection. The other subscri-
ber is then put on hold.
5.12 Call transfer (switching)
When a call is transferred, the active subscriber and the subscriber for the connection
previously put on hold are always connected with one another.
You can initiate an enquiry call yourself (e.g. in order to announce the call) and can then
transfer the call.
R
g
Call with sub-
Subscriber 1
scriber 1
is put on hold
Please note that this performance feature (ECT - Explicit Call Transfer) must be sup-
ported by the PABX system when transferring two (2) external calls, or, when you
use your phone directly on the NTBA, by your network service provider.
T
. You are then returned to the call that was
S
g
Call with sub-
conn2
scriber 2
t
g
Call with sub-
Dial number
scriber 2
106
S
d
Conference with sub-
conf
scriber 1 and 2
S
x-fer
Advertisement
Table of Contents
