Heating/Cooling Request Objects - MDT SCN-RT1GW.01 Technical Manual

Technical Manual Glass Room Temp. Contr. SCN-RT1Gx.01

6.3.5 Heating/Cooling request objects

The following settings are available at the ETS-Software:
Figure 14: Heating/Cooling request objects
The following chart shows the dynamic range for this parameter:
ETS-text
Heating request object enabled
Cooling request object enabled
Table 38: Heating/Cooling request objects
The setti g Heati g/Cooli g e uest e a led
or cooling process. So these objects are status objects.
The objects can be used for the visualization of a beginning or ending heating/cooling process. So, for
example, a red LED could show a heating process and a blue LED a cooling process.
A further opportunity for the usage is the central switch of a heating or cooling process. So can be
realized that all heating devices of a building switch on, when a controller gives out a heating request.
The 1 Bit communication object gives as long a 1-signal out as the process is active.
The following chart shows the relevant communication objects:
Number Name
17 Heating request
18 Cooling request
Table 39: Communication objects heating/cooling request
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
48
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[default value]
 No
 Yes
 No
 Yes
a sho o je ts, hi h i di ates a egi i g heati g
Length Usage
1 Bit indicates a beginning heating process
1 Bit indicates a beginning cooling process
comment
activates the communication object for
the visualization of a beginning heating
process
activates the communication object for
the visualization of a beginning cooling
process